UNIFOLD Gutter Lining System
-
Model Specification
The following Model specification details the standard/basic components and installation method
for Unifold. To customise your specification please select components as required from the accessories listing...
Unifold Gutter Lining System as manufactured by
AMPTEAM Ltd., Turner Street, Dudley,
West Midlands DY1 1TX
Telephone No: 01384 252777 Fax No: 01384 252888
COMPRISING:
An E.P.D.M Synthetic Rubber Membrane 1.14mm thick permanently factory
bonded to 0.7mm galvanized steel sheet.
To include necessary bends and hinge(s) to provide maximum ease of
installation.
Gutter lining sections provided in standard 2800mm lengths, fixed with butt
straps provided and fully sealed in accordance with manufacturers instructions.
OUTLETS:
Patch type - supplied loose and cold vulcanised in position fully in
accordance with manufacturers instructions.
STOPENDS:
Supplied loose, fixed and fully sealed in accordance with manufacturers
instructions.
Installation Procedure - Back To Top
- Clean and reasonably dry the existing gutter(s)
- Lay sole board ( Extruded Polystyrene or similar approved ) between over and not over, existing gutter joints. (Thickness to suit height of bolt/nut/stud intrusions)
- Install Unifold stop-end at commencement of run and lay Unifold gutter lining system
fully in accordance with manufacturers instructions. Note: Sole board to be
installed together with the Unifold and at a similar pace.
- Determine position of existing outlets as lining progresses, cut hole in Unifold 5mm- 10mm
larger in diameter than existing and fit system outlets fully in accordance with manufacturers
instructions.
- Cold vulcanise Sureseal Pressure Sensitive membrane flashings, 150mm wide and to
the complete girth of the Unifold, over each joint area, fully in accordance with
manufacturers instructions.
- Provide system Tie-off kits ( 1 no per 50 metres ) as provided by Ampteam Ltd, to be used
for over-night weathering of incomplete runs and as emergency measures to prevent storm
water penetrating the Unifold and existing gutter cavity.
- Following completion and final inspection provide Unifold 20 year guarantee.
|
