Follow these pages and discover - UNIFOLD Gutter Liner Systems
Manufacture and Fabrication - Back To Top
The Unifold Gutter Lining System has a complete range of accessory
components and techniques which are able to
cope with any existing gutter conditions or
circumstances including an expansion and
contraction joint which may be used to allow
Unifold to move in conjunction with the
existing gutter as well as coping with normal
thermal and building movement.
Every effort is expended to factory fabricate
the Unifold Gutter Lining System to its most complete form possible
prior to shipment leaving site operatives the
simplest of tasks to install the system fully.
The Unifold Gutter Lining System is installed with the absolute minimum
of disruption to processes beneath by fully
trained professional contractors, who together
with Ampteam, provide a partnership to ensure
that every Unifold Gutter Lining solution is of the highest
quality in every respect.
A sole board is usually required beneath
the Unifold Gutter Lining System in order to provide a flat level surface
for the gytter lining system and to allow for bolt and
stud intrusions in the existing gutter.
The minimum thickness required is 10mm
which allows for bolt heads, however, thicker
boards will be required to allow for stud
intrusions if these are not to be removed.
If thicker boards are to be used consideration
should be given to gutter capacities.
Sole boards are usually insulation board and
Extruded Polystyrene is recommended,
however, Bitumen Impregnated Fibre Board is
acceptable.
|
